When ordering custom, all steel die sets, specify:

1. Type 2B, 2D, or 2C. Note: O & P should be different diameters on Type 2D & 2C die sets.
2. Dimensions A, B, J, K, and L.
3. Type bushings - sintered bronze bushings supplied unless otherwise specified.
4. Diameter of threaded shank, if wanted. See page 9 for Threaded Shank Selection Chart.
5. How shipment should be made.
6. Custom die sets may not be returned for credit.
7. Quantity needed.

When ordering custom, all steel die sets, specify:

1. This table shows accepted design dimensions. Any or all of these dimensions, however, can be changed to conform to customer's specifications of A, B, O, P, J, K, L, F or W, etc.
2. All die sets are always made so that the punch holder can not be reversed on die holder. Type 4Ps are made with same diameter posts, but the right front post is offset 1/8" toward outside edge of die set.
3. Any of these sets are available both with or without shank. Unless otherwise specified, shank is always located in middle of both A and B dimensions. For safety reasons, we supply only threaded shanks. See page 9 for Threaded Shank Selection Chart.
4. Die sets of design other than shown in catalog can be furnished in steel or aluminum.
5. Custom die sets may not be returned for credit.
6. Sintered Bronze Bushings supplied unless otherwise specified.

When ordering custom ball bearing die sets, specify:

1. Type 2BB, 2BD, or 2BC.
2. Dimensions A, B, J, and K.
3. Ball bearing die sets will be furnished with straight steel sleeve bushings or demountable ball bearing bushings.
4. Dimension "T" is minimum shut height.
5. Post diameter "O" & "P". (O and P should be different for 2BD and 2BC.)
6. Custom die sets may not be returned for credit.
7. Quantity needed.