Manufacturer Part# / Cross Reference Search
Please use this search function to find READY die set components that are equivalent to commonly used pins, bushing, ISO Springs, and Gas Springs from other manufacturers.
Please Note: We believe this cross reference to be accurate. Please review the specifications to ensure the item will work in your application. Gas Spring equivalents were based on body dimensions, on contact force and stroke length.
When ordering custom, all steel die sets, specify:
- This table shows accepted design dimensions. Any or all of these dimensions, however, can be changed to conform to customer's specifications of A, B, O, P, J, K, L, F or W, etc.
- All die sets are always made so that the punch holder can not be reversed on die holder. Type 4Ps are made with same diameter posts, but the right front post is offset 1/8" toward outside edge of die set.
- Any of these sets are available both with or without shank. Unless otherwise specified, shank is always located in middle of both A and B dimensions. For safety reasons, we supply only threaded shanks. See page 9 for Threaded Shank Selection Chart.
- Die sets of design other than shown in catalog can be furnished in steel or aluminum.
- Custom die sets may not be returned for credit.
- Sintered Bronze Bushings supplied unless otherwise specified.
Unit of Measure
Specifications
Brands |
N/A Ready |
Die Holder Thickness (J) |
N/A 1-3/4 in |
Punch Holder Thickness (K) |
N/A 1-3/4 in |
Post Diameter (O) |
N/A 1-1/2 in |
Dimension (F) for (O) Post |
N/A 2-1/2 in |
Dimension (C) for (O) Post |
N/A 1-3/4 in |
Note for Dimension |
N/A Dimensions furnished when customer specifies only A and B dimensions. |
Product Code |
N/A DS-C |
Note
Note |
N/A
Right front pin offset 1/8". It is recommended to finish heavy (point pressures) machining before grinding for best results. We do not recommend using steel and aluminum plates in a die set combination. |
