Ready Die Set Quote Form
When ordering custom, all steel die sets, specify:
  1. This table shows accepted design dimensions. Any or all of these dimensions, however, can be changed to conform to customer's specifications of A, B, O, P, J, K, L, F or W, etc.
  2. All die sets are always made so that the punch holder can not be reversed on die holder. Type 4Ps are made with same diameter posts, but the right front post is offset 1/8" toward outside edge of die set.
  3. Any of these sets are available both with or without shank. Unless otherwise specified, shank is always located in middle of both A and B dimensions. For safety reasons, we supply only threaded shanks. See page 9 for Threaded Shank Selection Chart.
  4. Die sets of design other than shown in catalog can be furnished in steel or aluminum.
  5. Custom die sets may not be returned for credit.
  6. Sintered Bronze Bushings supplied unless otherwise specified.
Unit of Measure

Specifications

Brands

 N/A Ready

Die Holder Thickness (J)

 N/A 1-1/4 in

Punch Holder Thickness (K)

 N/A 1-1/4 in

Post Diameter (O)

 N/A 1 in

Dimension (F) for (O) Post

 N/A 2 in

Dimension (C) for (O) Post

 N/A 1-1/2 in

Note for Dimension

 N/A Dimensions furnished when customer specifies only A and B dimensions.

Product Code

 N/A DS-C

Note

Note

 N/A Right front pin offset 1/8".

It is recommended to finish heavy (point pressures) machining before grinding for best results. We do not recommend using steel and aluminum plates in a die set combination.

Applications

Application

 N/A
  • Aluminum die sets.
  • Three and four platen die sets.
  • Plate work, ground or unground.
  • Stress relieved plates.
  • Die sets can be made with heel blocks.
  • Per print CNC machining, holes, keyways, cut-outs and burnouts.

Die Space

Dimension (A) (Left to Right)

 N/A 6 to 10 in